HOUSE OF CUSTOM Zodiac-New Zealand
Search our website
Products
Searching...

Shoppingcart

{{articleCount}} 0 {{articleString}} Articles
Previous Product
12 VOLT ALTERNATOR KIT FOR GENERATOR MODELS

12 VOLT ALTERNATOR KIT FOR GENERATOR MODELS

SAMWEL 12 VOLT GENERATOR REBUILD KIT FOR VINTAGE MODELS

Next Product
SAMWEL GENERATOR END CAP

SAMWEL GENERATOR END CAP

This complete kit allows you to rebuild your "32E" style generator as used on all 1932 thru 1964 Harley-Davidson V-Twins into a 12 Volt system. Does not change the appearance, so also great for your restoration project.


Specifications

Article number Description Retail price Add to cart
745832
Rebuild kit for 32E generator $679.13

Recommended Retail Prices include 15.00% sales tax.

Prices exclude shipping, import duties and installation.

Prices are based on EUR to NZD interbank rates obtained daily. The interbank rate is the rate that banks trade currency to each other. These prices must be used as a guide.

Polarizing generators and regulators
The following information and instructions are for your use, so your warranty will by in effect. No warranty can be in effect if these instructions are not followed. Whenever any component of a generator charged electrical system is serviced it is necessary to re-polarize the complete system, making sure it has the correct polarity so the system will charge in the right direction. If the system is put into service with the wrong polarity it may result in burned relay points, a dead battery and damage to both the regulator and generator.
Instructions:
1. To polarize a generator system with a mechanical regulator, momentarily connect a jumper wire of adequate gauge (a battery cable is ideal) between the “bat” and the “gen” terminal on the regulator after all wires have been properly connected and before starting the motor.
2. To polarize a generator system with electronic regulator/ rectifier. Before mounting the generator of the vehicle, place the generator on a non conducting work surface (like a wooden bench) and connect the positive terminal of a battery to the armature terminal of the generator. Then momentarily “flash” the negative battery terminal to the generator field terminal.